Dell 2355DN Service Manual page 22

1) Application Network:
2) Communication Mode:
3) Communication Standard:
4) Max. Modem Speed:
5) Encoding:
6) Transfer Rate:
7) Fax Modes:
8) Fax Contrast:
9) Fax Memory:
10) TX/RX Journal :
11) Tel/ID List:
12) Confirmation Reports for Send:
13) Management Reports:
14) TTI/RTI:
15) Line Control Unit (LIU):
16) Header Transmission
(Always On):
Line Interface Part
This is Connection Part between system and PSTN(Public Switched Telephone Network), and primary circuit
is usually located. Main functions are Line Interface, Telephone Connection and Line Condition Monitoring.
Service Manual
Product spec and feature
PSTN (RJ-11)
Half-Duplex, ITU V.8, V.34, V.17, V.29, V.21, V.27ter, ECM
- Modem will auto train down only.
ITU-T Group 3
33.6 Kbps
MH, MR, MMR, JPEG, JBIG
3 seconds (standard resolution, MMR, 33.6kbps, CCITT No.1, LTR)
Under 2sec(JBIG)
- Phase "C" by ITU-T No.1 Chart/Memory Transmission/ECM
- Standard (203 x 98 dpi)
- Fine (203 x 196 dpi)
- Super Fine (300 x 300 dpi)
Adjustable 3 levels (Light/Normal/Dark)
4MB (About 300 Sheets of CCITT No.1 Chart at standard
resolution). User selectable parameters will be stored in NVRAM.
Available.
Available.
- Upon successful transmission
- Upon failure
- Reduced image of first page (except OHD, and partial page for
complexity of the images)
- Customer On/Off selectable
- System Data List
- Image TCR for Memory TX
- TTI (Transmit Terminal Identification) printed at top of Fax Image.
- RTI (Receiver Terminal Identification) printed at bottom of Fax
Image the Transmitting devices fax number is substituted for
receiving devices fax number is this footer.
- Input Sensitivity : Not programmable
- Output Level : -9 to -15 dBm (programmable)
- Cable Equalization : Not programmable
- Input/Output Impedance : per PTT requirements (programmable)
- DC Resistance : per PTT requirements (programmable)
- Insulation Resistance : Minimum 5M ohm
- Local Machine date and time
- Local Machine ID
- Local Machine Name
- Transmit page count (3 digits)
2-13