Display Panel; Replacing The Display Bezel; Removing The Display Panel - Dell Studio 1555 Service Manual

WARNING: The following instructions are not applicable to Edge-to-Edge display panels, which should not be disassembled.
1. Follow the instructions in Before You
2. Remove the display assembly (see
CAUTION: Removal of the bezel from the display bottom cover requires extreme care to avoid damage to the bezel and the display panel.
3. Gently push the display bezel outwards on each of the four sides to release the bezel from the display panel.
1 display bezel
NOTE: In some computers, the display bezel has a double-sided tape on both ends. To avoid damage to the display bezel, remove the display bezel
carefully to free it from the double-sided tape.

Replacing the Display Bezel

1. Follow the instructions in Before You
2. Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the display panel.
3. Replace the display assembly (see
Display Panel

Removing the Display Panel

1. Follow the instructions in Before You
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the four screws securing the display panel to the display cover.
5. Using the camera cable pull-tab, disconnect the camera cable from the connector on the camera.
Begin.
Removing the Display Assembly).
Begin.
Replacing the Display Assembly).
Begin.
Removing the Display Assembly).
Removing the Display Bezel).