[]Outside Top Exhaust; Attach Mounting Plate To Wm1 - GE DVM1850DM Installation Instructions Manual

Installation Instructions
OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4. Mount Microwave Oven
A5. A(!just Exhaust Adaptor i
A6. Connect Ductwork
ATTACH THE MOUNTING
PLATE TO THE WALL
Attach tile plate to tile wall using toggle bolts.
At least one wood screw IlltlSt be used to attach
tile plate to a wall stud.
[]Remove tile toggle wings fl'om tile bolts.
[]Insert the bolts into the mounting plate
through the holes designated to go into drwvall
and reattach the toggle wings to _A" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l..-.[.--Th
ckness
ToggleWings
Mounting
Plate
Bolt End
_ Place tile mounting plate against tile wall and
insert tile toggle wings into tile holes in tile wall
to mount tile plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make sure tile tabs on tile mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet,
CAUTION: Be careflfl to axoid I)inching, finoers,_
between the back of the mounting plate and the wall,
_ Tighten all bolts, Pull the plate awax from the wall
to help tighten the bolts,
12