Changing Presser Foot; To Remove; To Attach; Presser Foot Types - Kenmore 385.15108200 Owner's Manual

Changing Presser Foot
OLever
(_)Groove
(_Pin
o To remove: Turn the handwheel toward you to raise the
needle to its highest position, Press the lever Oon the
back of the foot holder. The presser foot will drop off.
° To attach: Place the presser foot so that the pin(_on the
foot lines up directly below the groove (_of the foot holder,
Lower the foot holder to lock the foot in place.
Presser Foot Types
° Zigzag foot
Use this foot for both straight and zigzag stitching_
For:Straight stitch (Page 32)
Topstitching (Page 34)
Basic zigzag (page 40)
Bar tacking (page 44)
Button sewing (page 44)
Overcasting stitch (page 46)
Blind hem stitch (page 48)
Lace work (page 48)
Multiple zigzag stit.ch (page 50)
Decorative stitch (page 52)
° Straight stitch foot
Use this foot exclusively for straight stitching with the
center needle position.
For:Straight stitch (page 32)
Topstitching (page 34)
o Sliding buttonhole foot
Use this foot for manual buttonhole making_ It is marked
to h_Ip you measure a buttonhole accurately
For:Buttonhole sewing (page 54-56)
f
......... j
o Zipper foot
This foot can be set to sew on each side of the zipper.
The edge of the foot guides the zipper and keeps the
seam straight°
For:Zipper sewing (page 34-36)
o Satin stitch foot
Use this foot for satin stitching and outlining applique,
For:Satin stitch (page 40)
Monogramming (page 42)
Applique (page 42)
Shell stitch (page 50)
_J
J