On-Screen Display (Osd) Menus (Pelco Protocol) - Bosch MIC612 Installation Manual

MIC612 Thermal Camera
7

On-Screen Display (OSD) Menus (Pelco Protocol)

This chapter identifies and describes each OSD menu option, as well as the default setting for
each option, for Pelco protocol. For step-by-step instructions, see Section 9 Common User
Commands, page 59 and Section 10 Advanced Features, page 62.
To open the main Setup Menu in Pelco protocol: Press 95-PRESET for approximately 2
seconds. The screen Setup Menu appears.
Setup Menu
Exit...
Command Lock:
Bosch Menu
Camera Setup
PTZ Setup
Edit Password
*FastAddress:
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
* = Factory Setting
Focus / Iris: Select
Setup Menu Choices:
Menu
Exit
Command Lock
Bosch Menu
Camera Setup
PTZ Setup
Edit Password
FastAddress
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
NOTICE!
If commands are locked and you press Focus or Iris, the camera displays the on-screen
message: "Command is Locked."
Bosch Security Systems, Inc.
On-Screen Display (OSD) Menus (Pelco Protocol) | en
OFF
Not Set
Description
Exits the menu.
Allows or prohibits accessing locked commands. (If password is set,
you are prompted to enter the password. The default setting is ON.
Accesses the full MIC612 configuration menu and all MIC612
settings.
Accesses adjustable camera settings such as White Balance and
Night Mode.
Accesses adjustable pan/tilt/zoom (PTZ) settings such as tours, scan
speed, edit presets, limit stops, recording, and AutoPivot settings.
Changes the password.
Sets or changes a camera address.
Displays the current software versions.
Acknowledges and resets active alarms.
Restores all settings to their original default setting.
Clears all settings, including scene shots, tours, and recordings
stored in the MIC612 memory.
Installation Manual
53
F.01U.249.416 | 2.0 | 2012.09