Installation; Unpack Unit; Check Settings/Connections; Connect Unit To Mains - Bosch PLE-1MEXX0-XX Installation And Operation Manual

Plena Mixer Amplifier
5

Installation

5.1

Unpack unit

1.
2.
5.2

Check settings/connections

1.
2.
5.3

Connect unit to mains

CAUTION!
Before connecting power, always check the voltage indicator plate at the rear of the unit.
1.
2.
Figure 5.1 Power connection and voltage selector
Bosch Security Systems B.V.
Remove the unit from the box, and discard the packaging material according to local
regulations.
Use your fingernails to carefully peel off the protective plastic film from the label holders.
Do not use sharp or pointed objects.
Connect any additional equipment (see Section 6.1 Connecting inputs and
Section 6.2 Connecting outputs).
Check the settings (see Section 7.1 Unit settings).
Make sure the power switch on the front of the unit is set to Off.
Connect the power cord to the mains connector and plug it into the mains outlet.
Installation and Operation manual
Installation | en
PLE-1MExx0-xx | V1.0 | 2011.04
15