Honeywell LYNX Touch Security System User Manual page 50

USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS
Automation
Ready To Arm
Name
Type
Trigger Output
Start Zone Type Stop Zone Type
Not Used
Start System Operation Stop System Operation
Not Used
OR
Ready To Arm
Name
Type
Scene
Zone Type Fault Zone Type Restore
Not Used
System Operation 1 System Operation 2
Not Used
Ready To Arm
Zone Number Operation
Not Used
01
Action
None
Not Used
Save
Not Used
5000-100-189-V0
Scene
Action
None
Not Used
Save
Not Used
5100-100-071-V0
Save
5000-100-191-V0
9. Select "Stop Zone Type" or "Zone Type
Restore" (if "Scene" was selected in Type field).
The system displays the same options as the
previous step.
Note: If a Rule is being used to trigger a Z-Wave door lock,
when the system is Armed Stay or Armed Away, it is
recommended that "End of Exit Delay" be selected for
System Operation 1 or System Operation 2.
10. Select "Start System Operation" or "System
Operation 1" (if "Scene" was selected in Type
field). The following options are displayed:
Not Used
Arm Away
Any Burglary Alarm
Bell Timeout
Use the " " " " buttons to scroll to second
page of zone type options.
Start of Entry Delay
Kissoff
System Low Battery
Duress Alarm
11. Select "Stop System Operation" or "System
Operation 2" (if "Scene" was selected in Type
field). The system displays the same options as
step 10.
12. Select "Zone Number Operation". The system
toggles between the following options:
Not Used
Fault
Trouble
Alarm
Notes: 1. For Fault, the following zone types should not be
used: General Monitor, General Response, Resident
Monitor, and Resident Response.
2. When a zone has been deleted, please verify the
programming selection for Zone Number Operation.
If Trouble, Fault or Alarm is selected, the
system displays several new options. Proceed
to Step 13.
– 50 –
Arm Stay
Disarm
Any Fire Alarm
End of Exit Delay
Chime
Bypass
Reporter Failure