Advertisement
2. For installation on the harsh environment case
(HEC), remove the edge from the screen protector,
as shown in Figure 4.
Figure 4. Removing Screen Protector Edge Strip
3. Peel the protective film from the adhesive side of
screen protector as shown in Figure 5.
Figure 5. Removing Adhesive Backing
4. Apply the screen protector with the adhesive side
down and the notch in the lower left corner as
shown in Figure 6. Apply pressure along the edges
of the screen protector with your finger. (Avoid
lifting the screen protector from the display
window after it is installed. The adhesive requires
48 hours to cure completely.
Figure 6. Applying the Screen Protector
2 of 2
5. Remove the protective film from the top surface of
the screen protector as shown in Figure 7.
Figure 7. Peeling the Protective Film
6. Wipe the exposed surface of the screen protector
with a clean dry cloth to remove any tacky residue
left behind by the protective film. If necessary, clean
the surface of the HEC window with a soft cotton
cloth dampened with denatured alcohol to remove
the residue.
Adjusting the handstraps
The handstrap assembly on the rear of the HEC can
be adjusted to provide a more comfortable fit. The
handstrap consists of two parts: a strap and a
cushion (see Figure 8). To adjust the handstraps, peel
apart the two sides of each handstrap cushion; they
are secured with Ve
from the cushion and adjust it to the proper fit.
Resecure the strap and close the cushion
Handstrap Cushion
Handstrap Assembly
Figure 8. HEC Handstrap Assembly
Pull the nylon strap away
lcro®.
.
Strap
58-0659-00A
0
Advertisement
