Storage Drawer Removal And Replacement; Changing Oven Light - Kenmore 790.4676 Series Use & Care Manual

General Care & Cleaning (cant'd)
Models with Ceramic Glass Cooktop (cant'd)
Do not use the following on the ceramic gloss cooktop:
* Do not use obroslve cleaners and scouring pods, such as metal and some nylon
pads. They may scratch the cooktop, making it more difflcult to cleon.
* Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners,
as they may etch or discolor the cooktop.
* Do not use dirty sponges, cloths or paper towels, as they con leave soll or llnt on
the cooktop which con burn and cause discoloration.
Special Caution for Aluminum Foll and Aluminum Cooking Utensils
* Aluminum loll
Use of aluminum foil will damage the cooktop. Do not use under any circumstances.
* Aluminum utensils
Since the melting point of aluminum is much lower than that of other metals, care must be taken when aluminum pots or
pans are used. Pans that boil dry may permanently damage cooktop by breaking, fusing to, or marking it.
Care and Cleaning of Stainless Steel (Stainless Steel models only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the General Core & Cleaning section in
this Use & Care Guide.
Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed to
facilitate cleaning under the range. Use care when handling the drawer.
Removing and Replaclng Storage Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the roller
guide stop, and push in.
//
toiler Storage
Drawer
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the
oven light on during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is dosed by using the oven light switch located on the Electronic Oven
control.
The oven light bulb is covered with a glass shield held in place by a wire hoiden
THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off: at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
23