Electronic Ignition - Kenmore 146.23674310 Use & Care Manual

Troubleshooting (continued)
_0
Burner(s) will notlight
usingigniter.
(See Electronic
Ignition
Troubleshooting also)
Burner(s) will n ot
match lighL
ELECTRONIC IGNITION:
• No spark, no ignition noise
• No spark, some ignition noise
• Sparks, but not at electrode or at full
strengtL
• See "GAS ISSUES:"on previous
page
° Match will not reach
° Improper method of match-lighting
• See Section I of Electronic Ignition System.
• See Section II of Electronic Ignition System.
• See Section III of Electronic Ignition System.
• Use long-stem match (fireplace match)
• See "Match-Lighting" section of Use and Care
• Check for gas in LPcylinder
Sudden drop in gas ° Out of gas
flow or low flame
° Excessflow valve tripped •Turn off knobs,wait 30 seconds and light grill If flames are
still low, turn off knobs and LPcylinder valve Disconnect
regulator Reconnect regulator and leak-test Turn on LP
cylinder valve, wait 30 seconds and then light grill
• Vapor lock at coupling nutiLP •Turn off knobsand LPcylinder valve Disconnect coupling nut
cylinder connection from cylinder Reconnectand retry
Flames blow out
Flare-up.
Persistent grease fire
• High or gusting winds.
• Low on LPgas.
• Excess flow valve tripped.
• Grease buildup
• Excessive fat in meat
• Excessive cooking temperature
° Grease trapped by food buildup
around burner system.
Flashback. • Burner and/or burner tubes are
(fire in burner tube (s)) blocked.
• Turnfront of grill to face wind or increase flame height
• Refill LPcylinder
• Referto "Sudden drop in gas flow" above
• Clean burners and inside of grill/'firebox
• Trim fat from meat before grilling
• Adjust (lower) temperature accordingly
• Turn knobs to OFF Turngas off at LPcylinder Leave lid in
position and let fire burn out After grill cools, remove and
clean all parts.
• Turn knobsto OFF Clean burner and/or burner tubes See
burner cleaning section of Useand Care. 40