Kenwood MC-60A Instruction Manual

DESKTOP MICROPHONE
INSTRUCTION MANUAL
Thank you for purchasing this MC-6OA desktop microphone.
This rrricrophone has been designed expressly for use with
your amateur communications system. It provides excellent
performance when used with any KENWOOD transceiver,
thereby upgrading your existing system.
The zinc die-cast base offers improved stability and is
complete with a feather-touch PTT switch, an impedance
selector switch, and a built-in preamplifier.
The microphone is constructed of precision parts. Do not
open the microphone as it may result in serious damage.
The microphone is sensitive to shock and vibration. Treat
it with care.
50W500 IMP. Switch rON/OFF Switch
WIIC AMP INIOUT
(Underside)
UP/DOWN Switch
Connect to
Radio Mic
Terminal
LOCK Switch
-
PTT Switch
KENWOOD
KENWOOD CORPORAl'ION
0 B62-1643-00 (M)
0 9 0 8 0 7 0 6 0 5 0 4 0 3 0 2 0 1 00
Installing the Batteries
1 Remove the 4 screws from the base of the
rrricrophone and gently separate the base from the
rr~icrophone unit.
2 Insert two AA batteries into the battery compartment,
being sure to match the polarities with those marked in
the compartment.
3 Replace the 4 screws.
Note: If your transceiver supplies power through its microphone
connector, you do not need to install the two AA batteries.
111 Batteries
"AA" hlkaline
(Not Ni-Cd)
Il
Connecting to the Transceiver
1 Slide the microphone into the bracket on the base
stand.
2 Connect the non-coiled cable ,from the rear of the base
stand to the rear of the microphone.
3 Connect the retractable cable from the base to the
transceiver's microphone jack.