Table of Contents
Advertisement
COMPLETING INSTALLATION
After you have connected all the necessary cables, you can push the
CD-ROM completely into the slot. There are 12 screw holes on the
XM-6401B that are used to mount the CD-ROM into your computer.
The screw length should not exceed 3±0.5mm (measured from out-
side surface of side or bottom of CD-ROM to tip of screw). Replace
the computer's cover, and replace all outer screws.
Mounting Screw
M3
Mounting frame of
host computer
Surface of side or bottom
of CD-ROM drive
3 ±0.5mm
Mounting CD-ROM
SOFTWARE
In order for your computer to recognize the CD-ROM, you must in-
stall a CD-ROM software driver. If you do not have this software
driver, contact the manufacturer of your SCSI host adapter card. Use
the instructions that came with your software to install the CD-ROM
software driver.
11
TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive
Hide quick links:
Advertisement
Table of Contents
