Setting The Initial Settings; Tachometer Unit; Speedometer Unit; Fuel Management Meter Unit - Yamaha 6Y8- 2819U-00 Owner's Manual

Setting the initial settings

Before operating the meter, be sure to
change the default settings as described
below. For the setting procedures, see the
corresponding setting procedure for each
meter.

Tachometer unit

ENGINE NUMBER (setting corresponding
engine)
Select the engine compatible to this meter.
(See page 19.)
TRIM 0SET (setting trim angle)
Adjust the trim angle to zero. (See page 13.)
DISPLAY (setting displays)
When the optional cooling water pressure
sensor is connected, change the display
configuration number so that it can be dis-
played in the cooling water pressure display.
When the oil pressure display function is not
available on your model, change the display
configuration number so that the oil pres-
sure display is not included. (See page 13.)

Speedometer unit

FUEL SENSOR (setting fuel sensor)
Set the fuel sensor according to the fuel
tank type. (See page 33.)
DISPLAY (setting displays)
When the optional Triducer-Multi sensor and
GPS are connected, change the display
configuration number to display the ambient
water temperature, depth, and clock dis-
plays. (See page 30.)

Fuel management meter unit

TANK CAPA. (setting fuel tank capacity)
Set the capacity of the connected fuel tank.
(See page 44.)
Setting the initial settings
DISPLAY (setting displays)
Change the display configuration number as
necessary so that the AVAL display can be
displayed. (See page 42.)
Speed & Fuel meter unit
FUEL SENSOR (setting fuel sensor)
Set the fuel sensor according to the fuel
tank type. (See page 61.)
DISPLAY (setting displays)
When the optional Triducer-Multi sensor and
GPS are connected, change the display
configuration number to display the ambient
water temperature, depth, and clock dis-
plays. (See page 57.)
64