Care And Cleaning - Kenmore Sears 87451 Use And Care Manual

CARE AND CLEANING
Wipe the microwave inside and out wilh a soft cloth and a mild detergent solution. Then rinse and wipe dry. This
should be done on a weekly basis--more often if needed. Never use rough powders or pads.
REMOVABLE PARTS
The following removable parts may be removed as described. They should be washed in warm (not hot) water
with a mild detergent and a soft cloth. Once they are clean, rinse them well and dry with a soft cloth. Never use
rough cleaning powders, steel wool or rough cleaning pads.
After each use of the temperature probe, it must be removed .from the socket. Use pot holder, as the wire, plug
and sensor sections may be hot. Wipe food or liquid from the sensor with a soft damp cloth.
The glass tray may be removed for cleaning at the sink. Wipe up spillovers with a paper towel or cloth before
removal of the tray. Be careful not to chip or scratch the edges of the tray as this may cause the tray to break
during use.
The oven inside top (stirrer shield) can be gently wiped in place or removed for washing at the sink.
Excessive oil spatters on the inside top (stirrer shield) will make them difficult to remove, ifleft for many days.
Wipe them with a wet paper towel especially after cooking chicken or bacon.
The stirrer shield is held in the inside top of oven cavity by one plastic pin at the front and four shield tabs
fitting into the slots at the rear and the front. To remove it, pull the shield down while you are pushing it
backward. Be careful not to lose the plastic pin during removal. Wash only in warm (not hot) detergent water,
rinse, and wipe dry. Avoid hitting or bending the metal stirrer blades, as this could cause uneven cooking or
microwave power loss.
To replace the shield, position it in the top of the oven cavity and retain it with the plastic pin in front.
SPECIAL CARE
For best performance and safety, the inner door panel and the oven front frame should be free of food or grease
buildup. Wipe both often with a mild detergent. Then rinse and wipe dry. Never use rough powders or pads.
After cleaning the control panel, touch CLEAR. This will clear any entries that might have been entered
accidentally while cleaning the panel.
/
1
\
o
anD iarml_D
m,'aa a nti i_
m"lam:'aa i _
i_at_ia_3
g_I_IMD
t9