How To Connect Wiring To The Terminal; How To Install The Timer Wired Remote Controller; Note - Panasonic R410A Installation Instructions Manual

Loose wiring may cause the
WARNING
terminal to overheat or result
in unit malfunction. A fi re
hazard may also exist.
Therefore, ensure that all
wiring is tightly connected.
When connecting each power wire to the corresponding
terminal, follow the instructions on "How to connect wiring
to the terminal" and fasten the wire securely with the fi xing
screw of the terminal plate.

4-4. How to Connect Wiring to the Terminal

For stranded wiring
(1) Cut the wire end with a wire cutter or wire-cutting
pliers, then strip the insulation to expose the stranded
wiring about 3/8 in. (Fig. 4-1)
(2) Using a Phillips head screwdriver, remove the terminal
screw(s) on the terminal plate.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring pressure
terminal. (Fig. 4-1)
(4) Place the ring pressure terminal, and replace
and tighten the removed terminal screw using a
screwdriver. (Fig. 4-2)

5. HOW TO INSTALL THE TIMER WIRED REMOTE CONTROLLER

NOTE

Refer to the Instraction Manual attaehed to the Timer Remote Controller.
Stranded wire
Fig. 4-1
Special
Screw
washer
Ring pressure
terminal
Terminal plate
Wire
Fig. 4-2
23
Ring
pressure
terminal
Screw and
Special washer
Ring
pressure
terminal
Wire