GE Monogram ZET857SYSS Installation Instructions Manual page 12

Installation
30" Built-I. ( o_vectio. Ove.s
Step 6
Replace the
oven door
• Grasp door th-n:ly on both sides,
• Slide the hinge slots ill the bottom of the cloor over
the hinges.
• Push tile cloor all the way in against oven.
• ()pen the door thlly and push hinge latches down,
as illustrated, on both sides to secure.
• (;lose the door and open slowly to be sure it moves
smoothl>
Step 7
Connect
electrical
Electrical Shock Hazard
• Electrical ground is required on this
appliance.
• I)o Not connect to the electrical
supply until appliance is
permanently grounclecl.
• Disconnect power to the junction box beli>re
making the electrical connection.
• This appliance must be connected to a grounded,
metallic, permanent wiring system, or a grounding
connector shoulcl be connected to tile grounding
terminal or wire lead on the appliance.
Failure to do so could result in a fire, personal
mjnry or electrical shock.
• When connecting to a 3-conductor branch circuit:
-Connect oven recl lead to branch circuit recl leacl.
-Connect oven |alack lead to branch circuit black
lead.
-Connect oven bare copper conductor and white
lead to branch circuit neutral lead (white or gray).
Junct:on Branch Circuit
Red Black
White.
Bareo
Green
Wires
CaNe U L-Listed
FromOven ConduitConnector
• When connecting to a 4-conductor branch circuit:
-Connect oven recl lead to branch circuit recl leacl.
-Connect oven |alack lead to branch circuit black
lead.
-Break connection between oven white lead and
oven bare copper cl)t)dtlctor.
-Connect oven white lead to branch circuit neutral
lead (white or gray).
-Connect oven bare copper conductor to branch
circuit grouncl lead (green or bm-e copper).
Note: Usecopperwire only.
Junction Branch Circuit
Red
White
Wires
Barn or
Green CaNe UL Listed
Wires From Oven Conduit Connector
12