Kenmore 2.0 & 3.5 gallon warm mist humidifier 997.151230 Owner's Manual page 14

HELP PAGE
Power light _ is not illuminated.
• Be sure Power Control Knob is in the HIGH or LOW position.
• Be sure humidifier is plugged into the outlet.
• Check outlet or circuit breaker.
Humidity light 6 is illuminated.
• The Humidity light 6 illuminates when the humidity in the room
matches the setting of the Humidistat Control Knob. If the
humidity in the room should drop below the Humidistat Control
Knob setting, the Humidity light • will shut off and the
humidifier will start producing warm mist again.
Mist output is minimal or none.
Be sure Power Control Knob is in the HIGH or LOW position.
Be sure humidifier is plugged into the outlet.
Check absorption sleeve for mineral buildup.
(see pages 8-9; REPLACING THE ABSORPTION SLEEVE and
page 9; CLEANING THE ABSORPTION SLEEVE).
Refill light _ is illuminated with water in tank(s).
If the tanks have water and the Refill light a! illuminates, check
to see if tank is properly seated on the base (right tank on
3.5 gallon model) and engaging the Safety Switch located on
the right side of the mist chamber (see page 6; SET-UP NOTE).
Cloudy film on tank(s) surfaces.
• See page 10; CLEANING THE TANK(S).
page 13