Advertisement
Problem
Dehumidifier does not
start.
Possible
Causes
Solutions
......
r
The dehumidifier is un-
Make sure the dehumidifier'spiug is I_ushed
plugged,
completely into the outlet.
,, ,,,,
Dehumidifier is not
operating as
Intended.
Filter Indicator is lit.
The fuse is blown I cir-
cuit breaker is tripped.
Dehumidifier has
reached the user set
humidity level or the
bucket is full.
Bucket is not in the
proper position.
Power Failure.
i Not enoughtime
al-
lowed for unit to remove
, mou:;ture.
Airflow is restricted.
Dirty filter.
,
,,,,, ,,,,,,,
The user set Humidity
Level may not be set low
enough.
,,,
,,,, ,,,,,,,,,,,,,
Doors and windows may
not be closed tightly.
Water is not draining
throughdrain hose
Room temperature is too
low.
Filter needs to be
cleaned every 250 hours
of use.
Check the house fuse I circuit breaker box and
replace fuse or reset breaker.
The dehumidifier automatically turns offwhen
either condition occurs. Change to a I_wer
setting or empty the water bucket and replace
properly.
, ,,,,,,,,,
The bucket must be in place and securely
seated for the dehumidifier to operate.
.....
,, ,,,,,
There is a protective time delay (up to 3 min.)
to prevent tripping of the compressoroverload.
For this reason, the unit may not start normal
dehumidification for 3 min. after it is powered
back on.
,,, ,,,,
When first installed,allow at least 24 hoursto
achieve the desired humidity level.
, ,, ,,,,,,
.............
Make sure there are no curtains, blinds, or
furniture blocking the side or back of the de-
humidifier.
,, ,,,,,
See the Cleaning The Air Filter section
To reduce moisture, press the down arrow
button to lower the percent humidity desired in
the room, or set the dehumidifier to CO for
continuous operation.
Check that all doors, windows, and other
openings are securely closed.
,, ,,,,,,,,,,,,, . ......
Make sure the drain is placed below the drain
connector nozzle to allow gravity to drain the
water (Refer to Gravity Drain Hose section in
this manual).
,, ,,,, ,,,,,.....
Moisture removal is best at higher room tem-
)eratures. Lower room temperatures will re-
duce the moisture removal rate. This model is
designed to operate at temperatures above
41°F.
,,, ,, ,,,,,,,,,,
...........
Once filter has been cleaned, press the FIL-
TER button for 3 seconds to turn the filter
indicator off.
!6
Advertisement
