Kenwood 103AR Instruction Manual page 6

103AR (En:
onnectionofsoeakers
I Strip coating.
Push lever.
Return ever
Speaker protection circuitry
Speaker system A
L
I _ r S_KERS
I((o))1 /
/
s k
Speaker system B
If the speaker cords are short-circuited, the speaker protection
c_rcudry _s activated and the sound i8 muted If this occurs,
switch the POWER key to OFF, remove the short-circuit from
the speaker cords, and switch the POWER key to ON again
Normal operation will resume
• Never short circuit the + and - speaker cords
• If the left and right speakers are connected inversely or if the
speaker cords are connected with reversed polarity, the sound
becomes unnaturar with ambiguous acoustic image posdiomng
Be sure to connect the speakers and speaker cords correctly
Setting the speaker IMPEDANCE SELECTOR
When using Ihe speaker A or speaker S separately
Speaker impedance Selector position
-II b
4 _, 6 _
Wbe_', _si_ 9 t_e speeker _, _d S slr_lt_r_o_sIv
Speaker impedance Selector position
8 _, 16 _
_'_,B, i I"lPi/'_ i_ I -
_L_/_U/IUI_I;TO PREVENT FIRE OR DAMAGE REQUIRING
SERVICE, SET THE IMPEDANCE SELECTOR
SWITCH AS DESCRIBED BELOW.
According to the impedance of the speakers used, set the speaker
IMPEDANCE SELECTOR on the rear panel as shown in the table
• When the IMPEDANCE SELECTOR switch is set to "AorB:
LESS THAN 8Q, AandB: RQ OR MORE", it is possible to use
the A and B speakers at the same t_me
Therefore, when using the speakers A and 8 s=multaneously, be
sure to set the IMPEDANCE SELECTOR swilch to the "AoPB:
LESS THAN _, AandB: 8_ OR MORE" position
• During speaker system connection and operation of the speaker
IMPEDANCE SELECTOR, set the REMOTE POWER key to OFF