Table of Contents
Advertisement
Rear Panel
ANALOG OUT (Analog output) 1/2 connectors (XLR type)
For connection to the analog input of a mixer, amplifier, etc.
The analog audio output level can be set from a menu.
DIGITAL OUT (Digital output) 1/2/3 connectors (1/2: XLR
type, 3: BNC-R)
Supply an AES3 format digital audio signal. For connection to the
digital input of a mixer, amplifier, etc.
LAN (Ethernet) (10/100) connector (RJ-45)
For connection to a 100Base-TX network.
Connect to a Windows computer or hub, for communication
using the supplied Wireless Studio software application.
ANTENNA a/b IN (Antenna a/b input) connectors (BNC-R)
For connection of the separately available UHF antenna AN-820
or the supplied whip antennas.
Antenna power supply can be set to 9 V or 12 V DC from
a menu. The power supply can be switched off when the
connected antennas do not require powering.
AC IN connector
For connection of the supplied AC power cable.
ANTENNA a/b OUT (Antenna a/b output) connectors
(BNC-R)
DWR-R01D can be connected to a and b, with support for
cascading of up to 8 units.
REM ANT (ST mode system antenna)
For connection of an external antenna for the ST mode system.
WORD SYNC IN/OUT (Synchronization signal input/output)
connectors (BNC-R) and 75-ohm termination switch
An external word clock sync signal can be connected to the
WORD SYNC IN connector to synchronize the digital output to
external equipment. (Word clock sample rate range: 32 kHz –
96 kHz)
The signal supplied to the WORD SYNC IN connector is passed as
is to the OUT connector.
Set only the 75-ohm termination switch on the last DWR-R01D in a
cascaded configuration to ON.
DWR-S01D Digital Wireless Receiver
Camcorder slot interface 2-channel receiver
Can be mounted also on camcorders without mounting slots,
by using the Wireless Adapter DWA-01D.
Antenna and antenna connector (BNC type)
Connect the supplied antenna here.
Mounting screw
Use to attach the receiver to a camcorder or DWA-01D digital
wireless adapter.
Accessory connector
Use to connect the receiver to a camcorder or DWA-01D digital
wireless adapter. Power, audio, and control signals are sent
through this connector.
USB connector
Connecting a USB keyboard to this connector allows menu
operation to be performed on the keyboard. Connecting the
transmitter to this connector through the supplied USB cable
allows an encryption key to be exchanged with the transmitter.
35
Audio Equipment Selection
Advertisement
Table of Contents
