Change The Light Bulb; Troubleshooting - Bosch Nexxt Premium WTMC6300 Operating, Care And Installation Instructions Manual

Changing the Light
bulb
The dryer light turns on inside the
drum when you open the door,
To change the light bulb:
Turn off the circuit breaker,
PutI out power supply plug,
Open the door and locate the
tight bulb on the upper teft side
of the seat,
Loosen the screw of the cover
and open the cover,
Turn bulb counterclockwise,
Replace the bulb with a new
appliance bulb onIy (obtainable
through customer service),
Replace the cover and secure
with the screw,
Ptug in dryer or reconnect
power suppty,
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only,
Before calling the customer service,
check whether you can rectify the
fault yourself by means of the
following table,
If a fault cannot be rectified or
a repair is required:
1. Set program selector to "Off",
2. Turn off the circuit breaker,
3. Pull the mains plug out of the
socket,
4. Call customer service
(see page 27),
Problem
Dryerdoesnotstart.
"Start/Stop"indicatorlight doesnot
illuminate.
Programhasbeen interrupted."Lint
filter" indicatorlight illuminates,
a warningsignalis emittedand the
displayshows"E:01 ",
Drumlightdoesnot function.
Possiblecause
Main plugnot inserted at all or not insertedcorrectly.
A fuse of powersupplyhastripped.
"Start/Stop"buttonnot pressed.
No programselected.
Doornot closed.
In Time-Programs d urationnot chosen.
Ambienttemperaturebelow41 °F/5 °C.
Lint filter dirty.
Exhaust a ir duct is blockedor too long.
Fault in programsequence or malfunction,
The room/cabinet i s not adequately ventilated.
No programselected.
Lightbulbdefective,lightbulbburnedout.
No powersupply.
Remedialaction
Insertmainplug correctly,
Replace/switch o n fuse,
Press"Start/Stop"button.
Selectprogram.
Closedoor.
Chosetime via "Select"-Button.
Increaseroomtemperature.
Cleanfilter asdescribedon page25.
Switchoff/switchon again.
Cleanexhaustair duct, Reduce exhaustair duct to
maximumlengthas described on page38.
Switchoff/switchon again.
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again.
Restartprogram.
Providean adequatesupplyof fresh air.
Switchoff/switchon again.
Selectprogram.
Changelight bulb,seepage26.
Guarantee powersupply.
26