Relay Name; Trigger Relay; Com1; Serial Port Function - Bosch FW5 Software Manual

Camera Browser Interface
14.2.4

Relay name

The relay can be assigned a name here. The name is shown on
the button next to Trigger relay. The LIVEPAGE can also be
configured to display the name next to the relay icon.
14.2.5

Trigger relay

Click the button to switch the relay manually (for example, for
testing purposes or to operate a door opener).
14.3

COM1

For cameras with a data connector, use this menu to configure
the data transfer.
14.3.1

Serial port function

Select a controllable unit from the list. If you wish to use the
serial port to transmit transparent data, select Transparent.
Select Terminal if you wish to operate the unit from a terminal.
After selecting a unit, the remaining parameters in the window
are set automatically and should not be changed.
14.3.2

Camera ID

If necessary, enter the ID of the peripheral you wish to control
(for example a dome camera or pan/tilt head).
14.3.3

Baud rate

Select the value for the transmission rate in bps.
14.3.4

Data bits

The number of data bits per character cannot be changed.
14.3.5

Stop bits

Select the number of stop bits per character.
14.3.6

Parity check

Select the type of parity check.
14.3.7

Interface mode

Select the desired protocol for the serial interface.
Bosch Security Systems Software manual
Interfaces | en
AM18-Q0605 | v5.0 | 2011.07
85