Output Programming Program Addresses (2734, 2735, 2736) - Bosch DS7400Xi Reference Manual

10.7 Output Programming: Program Addresses (2734, 2735, 2736)
Output programming defines the event, partition, and type of alarm (burglary or fire) that will trigger each of the three physical outputs on
the control panel.
See section 3.0 for the location of the physical outputs on the control panel.
See Glossary (section 6.4) for further details.
Programmable Output 1 will
be ON for 10 seconds after
pressing [System Reset].
Programmable Output 2 will
be OFF for 10 seconds after
pressing [System Reset].
3
Options
Disabled
Armed Full
Armed Partial
Armed Any
** = This includes invisible zones. See glossary for further details.
*** = See section 6.4 for description of this option.
Output
Alarm
Programmable Output 1
Programmable Output 2
DS7400Xi ( 4+) Reference Guide
Select Option
Latch on ANY Zone Alarm**
ON during Entry Pre-Alert/Exit Warning
ON for 10 sec. after pressing [System Reset]
ON when system is Armed
Ground Start
System Status (ready to arm)
Zone Alarm
Zone Alarm delayed by 20 sec.
DD
Keypad Sounder Output
Access Output (10 sec. pulse)
0
1 Keyfob
Panic Duress Output***
2
3
On during battery test
Address
2734
2735
2736
Copyright © 2007 Bosch Security Systems, Inc.
Default
6 3
3 3
2 3
DD
0
1
2
Options
3
Disabled
4
Burglar Alarm
5
Fire Alarm
6
Burg and Fire Alarm
7
8
9
*0
*1
*3
Options
RF3334
Disabled
Momentary Option
Toggle Option
Momentary Auxillary
Toggle
Auxillary
P/N: F01U035325-01
Data Digit
1 2
DD
0
1
2
3
Data Digit
1 2
*0
DD
0
1
Key
2
Key
3
Key
4
Key
Page 41