Advertisement
Fire Hazard
Do Not make connection too tight. The
regulator is die cast.
Over-tightening may crack the regulator,
resulting in a gas leak and possible fire or
explosion.
manual shutoff
valve
(See Steo F on Panel B
flexible
connector
for prober location.)
.
pressur;
regulator
and normally
open
valve assembly
l/2" flar& union a>apters
All connections
must be wrench-tightened.
1101
' Assemble the flexible connector
from the manual shutoff valve (or gas supply
line from the shutoff valve) to the pressure
regulator. The pressure regulator is located on
the left, rear lower corner of the range. Use
pipe-joint compound made for use with Natural
and L.P. gas to seal all gas connections.
Make
sure flexible connector is not kinked. Seal all
openings in floor or wall where range is
installed.
ml
I
Open shutoff valve in gas supply
line. Wait a few minutes for gas to
move through the gas line.
Fire Hazard
Do Not use an open flame to test for leaks
from gas connections.
Checking for leaks with a flame may
result in a fire or explosion.
112)
.
Use a brush and liquid detergent to
test all connections
for leaks.
Bubbles around the connections
will indicate a
leak. If a leak appears, shut off gas valve
controls and adjust connections.
Then check
connections
again.
NEVER TEST FOR GAS
LEAKS WITH A MATCH OR OTHER FLAME.
Clean all detergent solution from range.
(131
.
Replace oven door by fitting both
corners of door over ends of hinges.
Push door evenly and completely onto hinges.
Remove nails from hinges. If door does not
close, you have not pushed door completely
onto hinges.
Replace storage drawer.
Place burner grates over burners
and caps. Turn on power supply.
To get the most efficient use
from your new dual fuel range, read
your KitchenAid Use and Care Guide.
Keep Installation
instructions
and
Guide close to range for easy
reference.
Numbers
correspond
to steps.
8.
Panel D
Advertisement
