Stacking Instructions - GE Spacemaker DSXH43D Owner's Manual

WARNING:
• To reduce the risk of electric shock, disconnect this
appliance from the power supply before attempting
any user maintenance. Turning the controls to the
OFF position does not disconnect this appliance
from the power supply.
• Refer to the washer and dryer installation instructions
prior to stacking appliances. Reading all of the
information contained in these instructions will simplify
the installation and ensure a correct and safe operation.
A fire hazard and/or personal injury could result from
improper installation.
TOOLS REQUIRED FOR STACKING
THE DRYER
• Phillips head screwdriver
• Channel-lock adjustable pliers

Stacking Instructions

19
MOUNTING THE DRYER TO
THE WASHER
The numbers in the illustration correspond to steps.
1. Remove the washer top panel by first removing the 4
screws in the 2 brackets located on the top rear of the
washer.
Slide the top forward, lift the front of the top up and
remove the top panel.
Remove the 2 brackets from the rear of the top panel.
2. Using the 4 screws that were removed in step 1, install
the brackets in the rear support as shown.
3. Remove the 4 screws and the 2 long front brackets
located on the top front of the washer.
4. Install the 2 new front mounting brackets provided and
the 4 screws that were removed in step 3. Note that the
tab of the front mounting bracket is facing forward as
shown in the illustration.