Jtf - Jump To Flash - GE 68K System User Manual

GE Energy Services

JTF - Jump To Flash

o
CPM
Platform
Use this command to place the D25 in Active Mode.
Description
The system stops execution out of the BootROM region, and it activates the FLASH
operating system.
Syntax Below is usage and syntax information for this command
Command Format
Variables
Parameters
Example
Special
Considerations
This command causes the D25 to shift into active mode immediately, without
!
performing any checks on FLASH.
Be sure that your FLASH region contains valid application data before invoking this
WARNING
command.
3-42
o o
D20 D20 ME
D20 Base D20 Base
jtf
None
None
Type jtf and press
Type yes to confirm.
Results: The system returns to FLASH operation mode.
The system must be operating out of BootROM to use this
command.
The system halts and deletes all applications currently
executing on the RTU when activating the FLASH operating
system.
SWM0023 1.00 2
o o
D20/200
CCU Base
.
ENTER
68K System Monitor
User's Guide
þ
D20/200 ME D25
CCU Base
General
Full Release