To Set The Clock; Power Failure - GE 164D2966P205-1 Use And Care Manual

OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the automatic oven timing functions to work properly.
The time of day clock cannot be changed during Delay Start. (It can be
changed during a regular bake or broil operation.)

To Set the Clock

1. Press CLOCK.
CLOCK
2. Press the number pads the same way
you read them. For example, to set 12:34,
press the number pads 1, 2, 3 and 4 in
that order.
Timer
You may program the timer to time cooking or other
household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
How to Set the Timer
1. Press TIMER ON/OFF.
TIMER
ON/OFF
2. Press the number pads to set the time.
For example, to enter 2 hours and 45
minutes, touch 2, 4 and 5 in that order.
If you make a mistake, press TIMER
ON/OFF and begin again.

Power Failure

If a flashing time of day is in the display, you have experienced a power
failure. Reset the clock. To reset the clock, press CLOCK. Enter the correct
time of day by pressing the appropriate number pads. Press START.
If number pads are not pressed within one minute
after you press CLOCK, the display reverts to the
original setting. If this happens, press CLOCK and
reenter the time of day.
3. Press START. This enters the time and
starts the clock.
START
To check the time of day when the display is
showing other information, simply press CLOCK.
The time of day shows until another pad is pressed.
When the timer reaches " :00," the control will beep
3 times followed by one beep every 6 seconds until
TIMER ON/OFF is pressed.
The 6 second tone can be canceled by following the
steps in the Special Features of Your Oven Control
section under Tones at the End of a Timed Cycle.
3. Press START.
START After pressing START, "SET" disappears;
this tells you the time is counting down,
although the display does not change until
one minute has passed.
4. When time is up, the oven control signals
until you press TIMER ON/OFF. Display
TIMER
then shows the time of day.
ON/OFF
NOTE: The minute timer is independent
of all the other functions and it does not
control the oven. The CLEAR/OFF pad
does not affect the timer.
(continued next page)
7