Table 28 Reset Response - Hitachi HDS723020BLA642 Specifications

General Operation Descriptions
9
9.1 Reset Response
There are three types of reset in ATA as follows:
Power On Reset (POR)
COMRESET
Soft Reset (Software Reset)
The actions of each reset are shown in Table 28.
Aborting Host interface
Aborting Device operation
Initialization of hardware
Internal diagnostic
Spinning spindle
Initialization of registers (*2)
Reverting programmed parameters to default
- Number of CHS
(set by Initialize Device Parameter)
- Multiple mode
- Write cache
- Read look-ahead
- ECC bytes
Disable Standby timer
Power mode

Table 28 Reset Response

Table Notes
(*1) Execute after the data in write cache has been written.
(*2) Default value on POR is shown in 0 Default Register Values on page57.
(*3) The Set Features command with Feature register = CCh enables the device to revert these
parameters to the power on defaults.
(*4) In the case of Sleep mode, the device goes to Standby mode. In other case, the device does
not change current mode.
(*5) Idle when Power-Up in Standby feature set is disabled. Standby when Power-Up in Standby
feature set is enabled.
The device executes a series of electrical circuitry diagnostics, spins
up the HDA, tests speed and other mechanical parametric, and sets
default values.
COMRESET is issued in Serial ATA bus.
The device resets the interface circuitry as well as Soft Reset.
SRST bit in the Device Control Register is set, and then is reset.
The device resets the interface circuitry according to the Set Features
requirement.
Hitachi hard disk drive specifications
56
POR COMRESET
- o
- (*1)
o x
o x
o x
o o
o (*3)
o x
(*5) (*4)
o ---- execute
x ---- not execute
Soft Reset
o
(*1)
x
x
x
o
(*3)
x
(*4)