Using Network Function
Network Connection
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each "Network Setup" setting and make sure to set the "Control I/F Select" to "LAN".
(see page 40)
When "LAN" is set, power indicator lights orange under the condition of power "Off" with remote control (stand-by
state).
Example of network connection
COMPUTER
Hub or broadband router
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• Use a LAN cable that is compliant with "CAT5" when connecting a device that supports 100BASE-TX.
• For instructions on how to connect, consult your network administrator.
LAN cable
Display (main unit, rear)
(not supplied)
45
45