Automatic Tv Channel Search - Yamaha DRX-2 Owner's Manual

Installing your DVD recorder
✘ I cannot switch my TV set to programme number "1"
✓ If you have connected additional devices to the EXT 2 AUX-I/O socket, please
disconnect these devices. Other connected devices may have switched the TV
set to the programme number of the scart socket.
9
Confirm with ENTER/OK on the DVD recorder remote control.
"WAIT" will appear in the display. The DVD recorder compares the TV channels
on the TV set and the DVD recorder.
If the DVD recorder finds the same TV channel as on the TV set it stores it at
"P01".
✘ "NOTV" will appear in the display. The DVD recorder is not
receiving a video signal from the TV set.
✓ Check the connectors at both ends of the scart cable.
✓ Check your TV's operating instructions to see which scart socket is used for
video signals.
✓ If the problem persists, you won't be able to use this feature.
Please read "Adding and clearing TV channels manually".
0
Wait until for example "TV 02" appears in the display.
A
Select the next programme number on the TV set, e.g. "2".
B
Confirm with ENTER/OK on the DVD recorder remote control.
Deleting sorting
You can delete incorrect TV channel sorting by pressing t.
C
Repeat steps 0 to B until you have assigned all the TV channels.
D
To end, press SYSTEM-MENU.

Automatic TV channel search

During installation, all available TV channels are searched for and stored. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the
DVD recorder, e.g. after moving house, you can start this procedure again. This will
replace the stored TV channels with the new ones.
What does Easy Link do?
With Easylink, you can search for and store TV channels only on the TV set. These
settings are accepted by the DVD recorder. Use this function to start the transfer
of TV channels from the TV set.
1
Switch on the TV set. If required, select the programme number for the DVD
recorder.
2
Switch on the DVD recorder using B/I.
3
Press SYSTEM-MENU on the remote control. The menu bar appears.
4
Select " " symbol with t or u.
5
Select "Installation" using w or v and confirm with u.
6
Select "Autom.search" using w or v.
Problem
Problem
Tip
Question
28