Table of Contents
Advertisement
System Operation
The USB Transceiver Module of the Toshiba NetPac
Wireless System must be inserted into the same USB port to
which it was installed for proper operation.
For additional information, see the section titled
Transceiver Installation" on page
ASD Setup Requirements
The ASD Transceiver Module of the ASD may be flashed
with the programming of a Coordinator or a Router. The
ASD system setup requirements are identical for both types.
•
Set parameter F003 to RS232/RS485.
•
Set parameter F004 to RS232/RS485.
•
Set parameter F851 to provide a system disposition in the
event of a communications loss.
2-Wire and 4-Wire Operation
The 7- and 9-Series ASD NetPac Wireless Systems may be set
for 2-Wire or 4-Wire operation.
The ASD must be set to the 2- or 4-wire configuration as
indicated on the transceiver module being used (see the module
part numbering convention on
For the 7-Series ASD, place jumpers at the
JP1 and JP2 terminals of the control board
(P/N 56000) as shown for half-duplex (2-
wire) operation.
Remove all jumpers for full-duplex(4-wire)
operation.
For the 9-Series ASD, place both switches of
SW200 of the terminal board in the On
position for half-duplex (2-wire) operation.
Place both switches in the Off position for 4-wire operation.
NetPac Wireless System
9.
page
10).
"PC USB
FULL
HALF
17
Advertisement
Table of Contents
