■
Battery Voltage Level
While transmitting, the transceiver automatically
checks the battery voltage level. When the voltage
level becomes low, the LED indicator flashes red.
When a tone sounds, transmission stops. Recharge
or replace the battery pack at this time.
■
Lamp
Press the key programmed as Lamp to toggle the
display backlight ON or OFF. The backlight
automatically turns OFF approximately 5 seconds
after it is switched ON.
Press any key other than Lamp while the backlight is
ON to reset the 5 second timer. The timer will reset
and the backlight will remain on for 5 seconds.
■
Beginning/ End of Transmission Signal
Your dealer can enable or disable the Beginning/
End of Transmission identification signals. These
signals are used to access and release some
repeaters and telephone systems.
To send a Beginning of Transmission signal, either
press the PTT switch, or press the
To send an End of Transmission signal, either
release the PTT switch or press the
by the # key.
•
Ask your dealer which method has been activated on
your transceiver.
28
key two times.
key followed