Temporary Operation; Preset Operation; Auto Restart Operation; Operation And Performance - Toshiba RAS-10, 13SKPX Series Owner's Manual

TEMPORARY OPERATION

11
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or
stop without using the remote control.
• Operation mode is set on
AUTOMATIC operation, preset
temperature is 24°C and fan
operation is automatic speed.
TIMER OPERATION
12
Setting the ON Timer
Press : Set the desired ON
1
ON
timer.
2
SET
Press : Set the timer.
3
CLR
Press : Cancel the timer.
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
ON
Press : Set the ON timer.
2
OFF
Press : Set the OFF timer.
• During the daily timer is activating, both arrows ( , ) are indicated.
Note:
• Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
13

PRESET OPERATION

Set your preferred operation for future use. The setting will be memorized by
the unit for future operation (except airfl ow direction).
1. Select your preferred operation.
PRESET
2. Press and hold for 3 seconds to memorize the setting.
The P mark displays.
PRESET
3. Press : Operate the preset operation.

AUTO RESTART OPERATION

14
To automatically restart the conditioner after the power failure (Power of the
unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to
set the operation. (3 beep sound and OPERATION lamp blink 5 time/
sec for 5 seconds)
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
blink)
• In case of ON timer or OFF timer are set, AUTO RESTART
OPERATION does not activate.
15 QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
QUIET
Press : Start and stop the operation.
Note: Under certain conditions, QUIET operation may not provide adequate
cooling due to low sound features.

COMFORT SLEEP OPERATION

16
To save energy while sleeping, automatically control air fl ow and
automatically turn OFF.
COMFORT
SLEEP
Press : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).

SLEEP TIMER OPERATION

17
To start the sleep timer (OFF timer) operation
Press SLEEP : Select 1, 3, 5 or 9 hrs for OFF timer operation.
1110250173.indd 3 1110250173.indd 3
18
Filter Reset (Some models only)
FILTER lamp lights on; the fi lter must be cleaned.
To turn off the lamp, push the RESET button on the indoor unit or the FILTER
button on the remote control.
Indoor Unit and Remote Control
Setting the OFF Timer
19
Press : Set the desired OFF
OFF
To protect bad smell caused by the humidity in the indoor unit.
timer.
SET
Press : Set the timer.
CLR
Press : Cancel the timer.
Note:
3
SET
Press .
SET
Press button during the
4
( or ) mark fl ashing.
20
Air conditioner operating conditions
21
• The power main switch is turned
• The circuit breaker is activated to
• Stoppage of electric current
• ON timer is set.
22
To separate using of remote control for each indoor unit in case of 2 air
conditioners are installed nearly.
Remote Control B Setup.
Note: 1.
MAINTENANCE
Firstly, turn off the circuit breaker.
• Clean the indoor unit and the remote control with a wet cloth when
needed.
• No benzine, thinner, polishing powder or chemically-treated duster.
SELF CLEANING OPERATION
1. If the button is pressed once during "Cool" or "Dry" mode, the fan will
continue to run for other 20 minutes, then it will turn off automatically.
This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the 3 times within 30 seconds.
• SELF CLEANING operation is default setting from factory.
• To cancel this function, press and hold the reset button on the indoor
unit for 20 seconds.
The SELF CLEANING operation will be cancelled. (5 beep sound but
OPERATION lamp does not blink)
• Do the same to set this function again. (5 beep sound and OPERATION
lamp blink 5 time/sec for 5 seconds)
• AUTO RESTART operation will be cancelled by setting or cancellation
of SELF CLEANING operation. Set it again if necessary.

OPERATION AND PERFORMANCE

1. Three-minute protection feature: To prevent the unit from being
activated for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating. This is
normal because the cracking sound may be caused by expansion /
contraction of plastic.
Temp.
Outdoor
Temperature
Operation
Cooling 21°C ~ 43°C
Dry 19°C ~ 43°C
TROUBLESHOOTING (CHECK POINT)
The unit does not operate. Cooling is abnormally low.
• The fi lters are blocked with dust.
off. • The temperature has been set
improperly.
• The windows or doors are
cut off the power supply.
opened.
• The air inlet or outlet of the
outdoor unit is blocked.
• The fan speed is too low.
• The operation mode is FAN or
DRY.
REMOTE CONTROL A-B SELECTION
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold CHK
button on the Remote Control by the tip of the pencil.
"00" will be shown on the display.
MODE
during pushing CHK . "B" will show on the display and "00"
4. Press
will disappear and the air conditioner will turn OFF. The Remote Control B is
memorized.
Repeat above step to reset Remote
Control to be A.
2. Remote Control A has not "A"
display.
3. Default setting of Remote Control
from factory is A.
EN
Room Temperature
21°C ~ 32°C
17°C ~ 32°C
2/3/10 3:04:11 PM 2/3/10 3:04:11 PM