Replacing The Lamp Unit - Panasonic PT-LW271U Operating Instructions Manual

Functional manual commercial use
Hide thumbs Also See for PT-LW271U:
Table of Contents

Advertisement

Note
The lamp replace tim
e, it is necessary to carry the following calculation. Confirm the lamp used time in the [LAMP settings]
z
(
Æ
page 41). (Values obtained by the following calculation formula contain a slight error.)
For PT-LX351E / PT-LW321E
Lamp use time = [Lamp used time (Normal)] + [Lamp used time (ECO)] × 0.75
For PT-LX321E
Lamp use time = [Lamp used time (Normal)] + [Lamp used time (ECO)] × 0.67
For PT-LW271E / PT-LX271E
Lamp use time = [Lamp used time (Normal)] + [Lamp used time (ECO)] × 0.83
3 000 hours
The usage period of
z

Replacing the Lamp unit

J
Attention
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the lamp, the
z
connector may be damaged.
Do not loosen other than designated screws.
z
Lamp cover
1 )
Turn off the power by following the procedure in "Powering off the projector".
(
page 27). Remove the AC power plug from the wall outlet. Wait at least 1 hour and
Æ
make sure the lamp unit and surroundings are cool.
2 )
Use a Phillips screwdriver to loosen the lamp cover screw and open the lamp cover.
Open the lamp cover by pulling it slowly toward the direction of the arrow.
z
3 )
Use a Phillips screwdriver to loosen the two lamp unit screws until the screws turn
freely. Pull up the handle, and pull out the lamp unit gently.
4 )
Insert the new lamp unit in correct direction. Tighten the two lamp unit screws
securely with a Phillips screwdriver.
5 )
Close the lamp cover, and tighten the lamp cover screw securely with a Phillips
screwdriver.
Reset the Lamp Hours Used
J
After replacing the lamp unit, make sure to reset the usage time in the [Clear Lamp Hours] menu. (
000 hours
/ 4
/ 4 500 hours / 5 000 hours is a rough estimate and is not guaranteed.
Handle
Lamp cover screw
Maintenance/replacement
Lamp unit screws
Æ
page 42)
55
ENGLISH -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-lx321uPt-lw271ePt-lx321ePt-lx351ePt-lw321ePt-lx271e

Table of Contents