Ipv6 Packet Filtering Configuration Example; Network Requirements; Configuration Procedure - HP 6125G Configuration Manual

IPv6 packet filtering configuration example

Network requirements

As shown in
so that every day from 08:00 to 18:00 the interface allows only packets from Host A to pass through.
Figure 3 Network diagram

Configuration procedure

# Create a time range from 08:00 to 18:00 every day.
<DeviceA> system-view
[DeviceA] time-range study 8:0 to 18:0 daily
# Create IPv6 ACL 2009, and configure two rules for the ACL. One permits packets sourced from Host
A and the other denies packets sourced from any other host during the time range study.
[DeviceA] acl ipv6 number 2009
[DeviceA-acl6-basic-2009] rule permit source 1001::2 128 time-range study
[DeviceA-acl6-basic-2009] rule deny source any time-range study
[DeviceA-acl6-basic-2009] quit
# Apply IPv6 ACL 2009 to filter incoming packets on GigabitEthernet 1/0/1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] packet-filter ipv6 2009 inbound
[DeviceA-GigabitEthernet1/0/1] quit
Figure 3, apply an IPv6 ACL to the incoming traffic of GigabitEthernet 1/0/1 on Device A
14