Add Virtual Volumes To Windows; Summary: Add Virtual Volumes To Windows Wizard - HP 3PAR StoreServ 7200 2-node Manual

Add Virtual Volumes to Windows

1. Select the virtual volume that you want to configure as a Windows disk. The virtual volume is
displayed as a virtual volume device.
If the volume is less than 2 TB, SmartStart initializes the Windows disk as Master Boot
Record (MBR).
If the volume is greater than 2 TB, SmartStart initializes the Windows disk as a Globally
Unique Identifier Partition Table (GPT).
2. In the Disk label for this virtual volume field, enter the Windows disk name to assign to this
virtual volume.
The disk label enables you to identify this virtual volume on the Windows server.
NOTE:
an apostrophe (') or quotation mark ("), can prevent the wizard from adding the virtual volume
to Windows successfully.
3. Select a drive to assign to the virtual volume, or select an empty NTFS folder to mount.
To mount a volume to an empty folder on a remote system, enter the drive and a folder name
that references the remote system (for example, C:\<remote_folder>). The network path
is not supported.
NOTE:
or is read-only, the folder might not mount successfully.
4. Click Next.
NOTE:
Troubleshooting Task Completion
If SmartStart displays the Failed to validate whether the current Windows task is complete message,
try the task again by using one of the following methods:
Click the Prev button, and then click Next.
Cancel and then restart the wizard.
If the problem persists, contact HP support. For more information, see
(page 57).

Summary: Add Virtual Volumes to Windows Wizard

Review your virtual volume disk device setup, and then click Finish.
Troubleshooting Task Completion
If SmartStart displays the Failed to validate whether the current Windows task is complete message,
click Finish again.
If the problem persists, contact HP support. For more information, see
(page 57).
38 Configure Storage
Do not use special characters in the disk label. Certain special characters, such as
Verify that the folder you mount is empty. If the folder does not exist, is not empty,
Adding virtual volumes to Windows might take up to 10 minutes.
"Support and Other Resources"
"Support and Other Resources"