Installation Instructions - NEC NFL-1265 Instruction Manual

INSTALLATION INSTRUCTIONS

Removing transit bolts
1. Before operating the washer, remove the
transit bolts(3 ea) along with the rubber.
• If the bolts are not removed, it may cause
heavy vibration, noise and malfunction.
3. Close the holes with the cap holders supplied.
Location of washer
• Check location where the washer will be installed. Make sure you have everything necessary for
correct installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any time.
• Install washer on an even horizonal floor.
If the washer is installed on an unsuitable floor, it could make
considerable noise, vibrate severely and cause a malfunction. If the
washer is not level, adjust leg up or down for horizontal installation.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
• Leave space around the washer upon installation
(right and left: 2cm, rear: 10cm)
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 3mm.
2. Unscrew the 3 bolts with the spanner
supplied. Keep the 3 bolts and spanner for
future use.
• Whenever the appliance is transported, the
transit bolts must be refitted.
4
Drain Hose
Washer
Laundry
Tub
approx.
2cm