Microphone Connection - Sony Ipela PCS-XG55 Integration Manual

1-1-3. Microphone Connection

The PCS-A1 and PCSA-A3 microphones can be connected to the input of the PCS-XG Series main unit.
In PCS-XG80/XG80S, the PCSA-A7 can also be used as the input. Up to two PCS-A1 and PCSA-A3
microphones, and up to 80 PCSA-A7 microphones (PCS-XG80/XG80S only, cascaded connection 40 +
cascaded connection 40) can be connected. When you connect the microphone(s) to the PCS-XG Series
main unit, pay careful attention to the positioning guidelines of each microphone described below.
PCS-A1, PCSA-A3 microphone layout
The positioning of the PCS-A1, PCSA-A3 microphones with the PCS-XG Series main unit is the same as
with other models in the PCS series. For details, refer to the Operating Instructions.
Two recommended audio setups (Case1 and Case2) are shown below.
Case1
Microphone
Suggested number
Input audio mode (microphone)
Output audio mode (loud speaker)
Setup menu confi guration
n *1 "Stereo or Monaural" depends on the setting of Input Mode/Output Mode of far end point.
* Place each loud speaker at least 1.5 m from the PCS-A1.
1-10
PCS-A1 x 2
4 to 6 persons
Stereo *1
Stereo *1
Communication:
Audio 1:
Audio 1:
Audio 1:
Audio 1:
Audio 1:
Loud
speaker
R
Loud
speaker
L
0.5 m to 1.5 m
PCS-A1 x 2
3 m or less
Audio mode MPEG4
Audio Input MIC
Input select (MIC) MIC (A1/A3)
Input Mode Stereo
Output Mode Stereo
Echo canceller On
1 m to 1.5 m
*1
*1
PCS-XG80