Place The Display On A Solid Surface; Battery Installation And Replacement - NEC E654 User Manual

Place The Display On A Solid Surface

Ensure that the LCD display is
placed in a position to allow free flow
of air� Do not cover the ventilation
openings on the back cover� Do not
place the display near any open
flames. Do not allow the display to
be placed in an environment where
it can be exposed to heat, direct
sunlight, or rain and water� Do not
expose the equipment to any liquid�

Battery Installation and Replacement

The remote control is powered by two 1�5V AAA batteries� To install or replace
batteries:
1� Open the battery cover of the remote
control by pushing and pulling it in the
direction of the arrow�
2� Insert two new "AAA" size batteries
for the remote control� When
replacing old batteries, push them
towards the springs and lift them out�
3� Match the batteries to the (+) and (-)
marks in the battery compartment�
4� Insert the bottom of the battery, the
(-) side, into the battery compartment
first, push towards the springs and
insert the top of the battery, the (+)
side, into place� Do not force the
battery into the battery compartment�
5� Close the battery cover making sure the tabs rest in the corresponding
holes and push down the cover until it clicks shut�
English-14
Min
1 m