GE RANGES JSP26 Owner's Manual page 9

i_ii_i i_i iiii_i_i _iI
FACE_%,
Never cook directly on the glass,
Always use cookware,
Always place the pan in the center of
the surface unit you are cooking on.
About the radiant surface units... (glasscooktops only)
The radiant cooktop feaulres heating
units beneath a smooth glass surface.
NOTE." A dight odoris normal w hena new
cooktop is usedforthefirst time.It is caused by
theheatingof newpartsandinsulating materials
andwill disappear i n a shorttime.
Tile surface unit will (_cle on and off to
maintain your selected control setting.
It is safe to place hot cookware on
the glass surface even when tile cooktop
is cool.
Even after tile surf_me units are umaed
off; tile glass cooktop retains enough heat
to continue cooking. To avoid over-
cooking, relnove pans fi'Oln tile suI(_lce
units when the food is cooked. Avoid
placing awthing on the surface unit until
it has cooled COlnpletely.
{{{iiiiiiili
{{{iiiiiiili
{{{iiiiiiili
{{{iiiiiiili
Beforeyouusethecooktopforthefirst time,
cleanit withcleaning cream.This helpsprotect
thetopandmakesclean-up easier
Water stains(mineral d eposits) a reremovable
usingthecleaning creamor full strengthwhite
vinegar
Useof window c/eanermay.leave an
iridescent film on the cooktop. Thecleaning
cream will remove this discoloration.
Don?storeheavyitemsabovethecooktop. I f
they. d ropontotheco&top,they. c ancause
damage.
Do not use the surfaceas a cutting board.
Donotslide
cookware across
thecooktop
because it can
scratch theglass--
the.glass is scratch
resistant, n ot
scratch proof.
Temperature Limiter
(glass cooktops only)
EveI T radiant StlI't-_|ce unit has a
telnperature lilniter.
The telnperamre lilniter protects dm
glass cookmp fl'Oln getting too hot.
Tile telnperamre lilniter may cTcle tile
units offfor a time if!
The pan boilsdry.
The pan bottomis not flat.
The pan is off center
There isno panon theunit.
Dual Surface Unit Switch (glasscooktops only)
Theleft rearsurfaceunithastwo cooking sizesto
selectfromso youcanmatchthesizeof theunit
to thesizeof theco&wareyouare using.
To use the large (9-inch) sm(>me unit,
push in tile top portion of the COILSIZE
switch next to the control knob. Push in
and mm the control knob to the desired
setting.
To use file small (6-inch) surface unit,
push in tile bottom portion of the COIL
SIZE switch. Push in and turn tile control
knob to tile desired setting.
9