User Interfaces; Software; Front Indicators - GE GEK-106465A Instruction Manual

4. USER INTERFACES

4.1.

SOFTWARE

CIO units need to be connected to a master unit, either an F650 or an F600. If the master unit is an F650, the CIO
can be programmed using EnerVista F650Setup program; in case of using an F600 as master unit, the CIO can be
programmed using GE-CONF software. In both cases, CIO inputs/outputs will be shown as if they were part of the
master unit, with the same programming options as the master unit I/O.
EnerVista F650Setup software provides a simple way to configure, monitor and maintain operation of F650 and the
connected CIO unit. Please refer to the F650 user manual for a more detailed reference about EnerVista F650Setup.
In the same way, please refer to GE-CONF software manual for details about programming a CIO unit connected to
an F600 master unit.
4.2.

FRONT INDICATORS

CIO units incorporate 2 LEDs on the front, one of them indicates that the unit is powered, and the other indicates
activity on the CAN bus.
GEK-106465A
USER INTERFACES
CIO Remote CAN Digital I/O Module 29