Sealed Burner Models; Standard Twin Burner Models - GE JGBP38 Use And Care & Installation Manual

Self-cleaning gas range

Hide thumbs

Table of Contents

PROBLEM

"F—AND A NUMBER"

FLASH IN THE DISPLAY

OVEN WILL NOT WORK

SURFACE BURNERS

LIGHT BUT OVEN

DOES NOT

QUESTIONS?

USE THIS PROBLEM SOLVER

POSSIBLE CAUSE

• If the time display flashed "F—and a number," you have a function error code.

If a function error code appears during the self-cleaning cycle, check the oven

door latch. The latch handle may have been moved, even if only slightly, from

the latched position. Make sure the latch is moved to the right as far as it will go.

Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven

back into operation.

• Disconnect all power to the range for 5 minutes and then reconnect power.

If the failure code repeats, then call for service.

• Plug on the range is not completely inserted in the electrical outlet.

• Pilot(s) is (are) not lit (on standing pilot models). See the Lighting Instructions

for Standing Pilot Models in Using Your Oven.

• The circuit breaker in your house has been tripped, or a fuse has been blown.

• Oven controls not properly set.

• The oven gas shut off valve may have accidentally been moved during

cleaning or moving.

To check the oven gas shut off valve on standard twin burner models, raise

the cooktop and look for the gas shut off lever at the extreme right rear corner.

(Standing pilot models do not have a gas shut-off valve on the regulator.)

Follow the directions in box A or B that match your regulator type.

Standard Twin Burner Models

To check the oven gas shut off valve on sealed burner models, remove

the storage drawer, broiler drawer or kick panel and look for the gas shut

off lever at the back of the range. On some models you may have to

remove an access cover also.

Follow the directions in box A or B that match your regulator type.

Standard Twin Burner Models