Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
You will need to connect the icemaker to a cold water line.
A water supply kit (containing copper tubing, shutoff valve, fittings
and instructions) is available at extra cost from your dealer or from
Service and Parts, 800-626-2002.
Refrigerator Location
Do not install the refrigerator where the temperature will go below
60°F. (16°C.) because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Clearances
Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
If built-in, allow 7/8 (22 mm) for hinge covers.
If the refrigerator is against a wall on either side, allow 3/4
(19 mm) for door clearance.
Sides . . . . . . . . . . . . . . . . . . . . . . . . . 5/8
Top . . . . . . . . . . . . . . . . . . . . . . . . . . 1 (25 mm)
Back. . . . . . . . . . . . . . . . . . . . . . . . . . 1/2 (13 mm)
(15 mm)
19