Interface Range - Motorola 549478-001-00 - PowerBroadband EthernetXD M2a WallPlate Switch User Manual

Commands and Syntax
where;
"wlan" is a keyword and must be typed
<1-25> is the port range for the radio connected to the DSL line
<1-16> is the port range of the WLAN on the radio
(interface-id) is a description and is not typed
Proper command form:
wifi wlan enable wlan25-1
Note that range commands can also be used. In the following example, WLANs 1, 2, 3 are enabled on all radios.
wifi wlan enable wlan(1-25)-(1-3)
This document refers to actual command syntax as little as possible. For a complete command syntax document,
please refer to the Command Reference guide for a complete list of all available commands, the proper syntax,
and usage examples. In no way does this User Guide attempt to replace or obsolete the Command Reference.

Interface Range

Multiple interfaces can be specified for a single command using port ranges. Use hyphens (-) and commas (,) to
delineate ports. Port numbers must be contained in parenthesis. Hyphens and commas can be combined in the
same expression to specify multiple, non-sequential interfaces. For example;
To enable all 25 DSL ports, type: interface dsl enable port(1-25)
To enable only selected DSL ports, type: interface dsl enable port(1,3,5,20-25)
Hyphens and commas can also be used to enable remote Ethernet ports along with DSL ports. For example;
To enable Eth1 and Eth2 on every WallPlate, type: interface remote enable port(1-25)-(1,2)
VLAN commands can also be completed using interface ranges.
To add VLAN 100 to Eth1 on every WallPlate, type: vlan membership add 100 interface port(1-25)-1
Motorola, Inc. 570510-001-00 rev A Page 11 of 50