Maintenance; Maintenance Schedule - Husqvarna DT18 Operator's Manual

Maintenance Schedule

The following is a list of maintenance procedures that must be performed on the machine. For those points not
described in this manual, visit an authorized service workshop.

Maintenance

Check the engine oil level
Replace engine oil
1)
Check the air filter
Clean the air filter
2)
Replace air filter cartridge
Clean sludge reservoir for fuel system
Check and clean the spark plug
Replace the spark plug
Check idle speed
Check and adjust play in valves
Clean fuel tank
4)
Check, replace fuel lines as necessary
Check clutch and clutch cable
Check flail blade lock washers
Check decals and warning signs
Check wear and tension on the belts
Check blade wear and condition
Check the chassis, bolts and set screws
Lubrication; see the Lubrication schedule
First change after 20 hours.
1)
lubricated twice weekly. Performed by authorized service workshop.
4)
No service operations may be performed on the engine or unit unless:
• The engine is stopped.
• The ignition cable has been removed from the spark plug.
• The machine is securely parked where it will not tip or begin rolling.
18 -
Husqvarna
MAINTENANCE
2)
4)
4, 5)
In dusty conditions maintenance is required at shorter intervals.
2)
WARNING!
Maintenance interval months/hours
Daily
before
starting 1/25
With daily use, the machine shall be
3)
Performed every second year.
5)
12/300
3/50 6/100