Rear Panel (With The Scsi Convertor) - Yamaha CRW2200S Series Owner's Manual

Front and Rear of Unit

Rear Panel (with the SCSI Convertor)

Jumper switch
Plug a plastic shunt into this jumper switch to set up SCSI ID, Parity, Terminator and
Block Size. ( P. 20 – 23)
SCSI INTERFACE connector
Insert the connector of the SCSI ribbon cable here. ( P. 26, 33)
DC IN connector (The SCSI convertor's side)
Insert the smaller connector of the power cable (included). ( P. 19, 34)
DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately). ( P. 17, 34)
ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this connector, and the other end to your
computer's sound card or built-in audio. ( P. 16, 34)
DC INPUT connector (The CRW2200 drive's side)
Insert the bigger connector of the power cable (included). ( P. 19, 34)
10