Tuner; Hdmi; Displayed Messages; Fm Wire Antenna - Pioneer LX01BD Operating Instructions Manual

Tuner

Problem
Considerable noise in radio
broadcasts.
Auto tuning does not pick up some
stations.

HDMI

Symptom
No picture or sound.
No sound, or sound suddenly
ceases.
HDMI Control does not function.

Displayed Messages

Message
192kHz PCM
SACD
DTS-HD
DTS Express
Dolby TrueHD
Dolby D+
No MIC
Muting
2ch Only
Exit
HDMI Through
Unknown
No Genre
HDMI C.ERR 2C*
Can't use
Remedy
• Connect the AM antenna (refer to Connecting up on page 10) and adjust the direction and position for best
reception. You may also connect an additional internal or external AM antenna (refer to Connecting external
antennas on page 42).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You may also connect an
outdoor FM antenna (see Connecting external antennas on page 42).
• Turn off other equipment that may be causing the noise or move it further away.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more sensitive
tuning, connect an outdoor antenna.
Remedy
• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible.
• Depending on the connected source component, it's possible that it will not work with this receiver (even if
it is HDCP-compatible).
• If the problem still persists when connecting your HDMI component directly to your monitor, please consult
the component or monitor manual or contact the manufacturer for support.
• Check that the HDMI Mode setting is set to AMP Mode/Through Mode.
• If the component is a DVI device, use a separate connection for the audio.
• Check the audio output settings of the source component.
• Verify that the HDMI cable is firmly connected.
• Make sure that this unit's HDMI Control mode is set to Control On (page 46).
• Check whether the connected component supports HDMI Control or not. For more information refer to the
operating instructions of your Flat Screen TV, HDD/DVD recorder, DVD player, etc.
• This unit does not guarantee HDMI Control-compatible components other than those made by Pioneer.
Description
These messages are displayed when you operate a function incompatible with the audio source being played
back.
Displays when you press MCACC when the MCACC setup mic is not connected.
Displays when you press TEST TONE or MCACC while this unit is muted.
An operation is prohibited because it is only applicable to 2 channel sources, while the current source is a
multichannel source.
Appears when a menu is automatically exited after a set period of inactivity.
Displays when you change the Listening Mode, the volume level, or some sound settings when the HDMI
Mode is set to Through Mode.
The genre information for contents being played back on a Pioneer HDD/DVD recorder cannot be obtained.
There is no genre set for contents being played back on a Pioneer HDD/DVD recorder.
The connected component is not compatible with synchronized genre mode.
• You tried to use Genre Sync Mode for a source component that does not support this function.
• The source component is in a situation where Genre Sync Mode cannot be used.
• You tried to use Genre Sync Mode when the input source of this unit is a source other than HDMI.
• The operation is forbidden due to the surround settings.
• When the volume level is over 51, some functions are restricted.
10
53
En