Section 2: Hd6 Scan Installation; Overview - Honeywell HD6 Series User Manual

2.1

OVERVIEW

The instructions and detailed information for installing and operating the HD6 are
contained in several sections. Instructions in this manual assume that the housing
installation is complete.
The following list is an overview of the installation steps, along with references to more
specific details. Follow the detailed instructions under each section/subsection
referenced.
Installation Process:
1. Set switches on the HD6 receiver board for correct protocol, baud rate, and parity.
(Refer to
2. Set W8 jumper on the video board for standard interface board or optional UTP
interface board. Jumper W8 enables or disables the 12V auxiliary power provided to
the housing interface board required by the UTP option. (Refer to
3. Install scan assembly. (Refer to
4. Remove or reinstall liner, as needed. (Refer to
5. Install the lower dome. (Refer to
Rev. 1.02
SECTION 2:
HD6 SCAN INSTALLATION
Section 2.2.)
5
Section 2.4.)
Section 2.5.)
Section 3.0.)
Section 2.3.)
900.0679
22-June-2006