GE 164D4290P393 Owner's Manual And Installation Instructions page 11

REMOVE EXHAUST ADAPTOR
2
If exhausting/venting using the 3
duct—optional for JV338, JV347 and JV367 models
only:
Remove the exhaust adaptor from the inside of the
hood. Set it aside along with its mounting screws.
" x 10"
3 1 ⁄
4
rectangular
exhaust
adaptor
and screws
3 REMOVE FILTER
Remove the shipping tape holding the metal grease
filter in place. Pull down on the center of the front
edge of the filter. The filter will then slip out of the
retaining tabs on the back.
Metal grease filter
REVERSE THE BAFFLE FOR
4
DUCTED INSTALLATIONS ONLY
(JV347 and JV367 models)
If the hood is to be recirculated, skip to the next step.
Remove the baffle from the top of the hood. Re-install
the baffle so the short side marked "VENTED" is
visible. The long side of the baffle should be inside
the hood.
"VENTED" is visible
Installation Instructions
" x 10" rectangular
1 ⁄
4
11
5 REMOVE WIRING COVER
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
6
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Back knockout
Top knockout
Strain relief
clamp
Strain relief
clamp