Install Duct Covers - GE CV936 Owner's Manual & Installation Instructions

7 INSTALL MOTOR
• Align and engage the
slots in the blower
assembly to the 3 hooks
at the rear of the
exhaust opening.
• Rotate motor upwards
until it aligns with the
attachment screw
location.
• Secure the motor to
attachment bracket at
the front of the
opening with washer
and screw provided.
• Plug the motor connector into
the mating hood connector.
See the illustration for the
hood connector location.
Touch the hood to locate and
make the connection.
IMPORTANT: Hold the connector so
the two square corner terminals
are at the top as you position
the connector to plug it in.
CONNECT ELECTRICAL
8
Verify that power is turned off at the source.
WARNING:
If house wiring is not 2-wire with a ground wire, a
ground must be provided by the installer. When house
wiring is aluminum, be sure to use cUL. approved anti-
oxidant compound and aluminum-to-copper
connectors.
A
Remove
C
Insert Power
Junction Box
Coduit Thru
Cover
Strain Relief
and Tighten
Ground
B
Check That White, Black and
Green Hood Wires Are Threaded
Thru Small Hole in Bracket
D
Use cUL Listed Wire Nuts
• Use wire nuts to connect incoming ground to green,
white to white and black to black.
• Push wires into junction box and replace cover. Be
sure wires are not pinched.
Installation Instructions
Motor Attachment Bracket
Motor Hooks
White
Black
9

INSTALL DUCT COVERS

To install the 12" duct cover alone:
• Place the 12" section of the decorative duct cover on
top of the hood.
• Secure the cover to the top of the hood with 4 screws
provided.
To install the 12" duct cover alone:
• Place the 2-piece duct cover on top of the hood.
• Secure the bottom cover to the top of the hood with
4 screws provided. See illustration, page 16.
• Extend the inside section upwards to meet the ceiling
and ceiling bracket.
• Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
INSTALL FILTER SUPPORT
10
• Tip filter support into the rear of the hood.
• Insert support tabs into the slots at the rear of the
hood.
• Secure the support to the hood with screws as shown.
1 Ft = 0.3 m
1" = 2.5 cm
17
Insert Tabs into Slots
Insert 2 Screws